Desired behavior:
When I make a blueprint and ensure "Snap to grid" --> "Grid position" --> "Absolute" is set, I would like the first time I place it to be in the same place I blueprinted it from. It should set the X & Y coordinates to whatever values would accomplish that based on the width/height and location it was blueprinted from. This way. I could build a rail line, decide I want a block width of, say 500 tiles, create the blueprint, and not need to fiddle with X & Y values to get it to do what I want.Current behavior:
When i take a blueprint, and make sure"Snap to grid" --> "Grid position" --> "Absolute" is set, my blueprint will usually not overlay my original, because the X & Y coordinates are defaulted to 0,0. Instead of fiddling with X & Y, I generally just use relative as usual, just being careful to line things up as I desire before placing.Hope this makes sense!