[kovarex] [1.1.11] Drag placing adds unexpected undergrounds without any obstacles

[bormand]

When I draw long bus lines, underground belts appear in the middle of the line without any obvious reason sometimes. There are no obstacles. And it's not an out-of-range issue that was solved in 1.1.11 since I get it mostly in the editor or sandbox mode.

In practice it happens quite rarely (mouse sensor glitches or system lags?), but I found a way to reproduce it almost every time:

1) Zoom out as far as possible
2) Start drawing a straight belt to the right
3) Move mouse some tiles to the left
4) Quickly throw mouse to the right

Actual: unexpected underground belt appears
Expected: normal belts are placed instead

Edit: screenshot:

Screenshot from 2021-01-15 01-39-51.png (335.99 KiB) Viewed 2197 times

Long gap on the middle belt may be related to the autosave that happened during drawing.

[irbork]

It may not be a bug. Maybe when you threw the mouse it bumped the keyboard or monitor and some buttons were presses.
Take good care of your mouse and it will take care of you

[bormand]

Maybe when you threw the mouse it bumped the keyboard or monitor and some buttons were presses.

That's why I throw it to the right

[kovarex]

This is probably related to other out of reach bug that I fixed for 1.1.12, so I consider this to be fixed until proven otherwise.

[bormand]

Still reproducible in 1.1.12, unfortunately. Here is a video:

output.mp4

(2.61 MiB) Downloaded 92 times

When smart drag is off, belts are placed normally, without any gaps.

[Loewchen]

Still reproducible in 1.1.12, unfortunately. Here is a video:

output.mp4

When smart drag is off, belts are placed normally, without any gaps.

That does not look like .12 behavior. If you are sure you have updated make a new and complete report please.

[kovarex]

I also can't reproduce.