Hello!
As title says, I noticed that sometimes I am unable to make the pump working as intended and transfer fluids into the fluid wagon.
I am using Krastorio 2 mod, as you can see here, I have 3 stations for Petroleum gas/light oil/heavy oil.
The one in the middle refuses to connect to the fluid wagon no matter if i remove and place again the pump.
I guess it has to do with the rail track position and the distance between it and the pump but even that close it still refuses to work.
[0.18.45] Pump not connecting to the fluid wagon
Re: [0.18.45] Pump not connecting to the fluid wagon
Make sure the train is automatically driven into the station.
Re: [0.18.45] Pump not connecting to the fluid wagon
It is, I've done that test too, the train stops on the station and still not connect with the pump
Re: [0.18.45] Pump not connecting to the fluid wagon
If you send the train around again, does it still not work after it returns? If yes, post a link to the save please.
Re: [0.18.45] Pump not connecting to the fluid wagon
From far away i can see the train is not properly aligned - pump looks almost across the center of the fluid wagon connector. You may back off the train a little on manual and then set it back to automatic. If you can reliably reproduce this state happening when train arrives on automatic i would like to look at the save file.
Re: [0.18.45] Pump not connecting to the fluid wagon
I have fixed by rebuilding the station again, probably the rail track was too close to the pumps.