What would be an OCD approved network for a basic structure of Roboports, large Powerpoles and Radar?

Post all other topics which do not belong to any other category.
Post Reply
andre2
Inserter
Inserter
Posts: 44
Joined: Fri Mar 04, 2016 2:25 pm
Contact:

What would be an OCD approved network for a basic structure of Roboports, large Powerpoles and Radar?

Post by andre2 »

Hi,
I just started out on anothe PY mods run. I´m still in the pre bus phase.

How would you create a network of large power poles, radar and roboports to cover the entire map?

I would go with max power pole range and max Roboport coverage. With radar also. Basically to save on resources.

Fishy
Inserter
Inserter
Posts: 24
Joined: Fri Feb 23, 2018 1:45 pm
Contact:

Re: What would be an OCD approved network for a basic structure of Roboports, large Powerpoles and Radar?

Post by Fishy »

4 Roboports will fit within the span of 6 power poles.

2 Radars will fit within the span of 6 Roboports


User avatar
jamiechi1
Long Handed Inserter
Long Handed Inserter
Posts: 54
Joined: Wed Jan 03, 2018 10:12 pm

Re: What would be an OCD approved network for a basic structure of Roboports, large Powerpoles and Radar?

Post by jamiechi1 »

I use my own chunk size of 48. I use Klonan's Big Wooden Pole and modify it to go 48 tiles.
Place a roboport next to each of those. Radars are placed next to every third roboport.
I place a bus between two of the roboports going either up/down or left/right.
Extend these 48 tile blocks in all directions as desired.

Post Reply

Return to “General discussion”

Who is online

Users browsing this forum: No registered users