[kovarex] [0.17.54] Crash when saving a single train loop with one signal

This subforum contains all the issues which we already resolved.
Post Reply
AngledLuffa
Fast Inserter
Fast Inserter
Posts: 183
Joined: Fri Jan 05, 2018 5:18 pm
Contact:

[kovarex] [0.17.54] Crash when saving a single train loop with one signal

Post by AngledLuffa »

Playing marathon deathworld, I (finally!) started building a train for uranium. I built a loop with a single signal, planning to go build the other side next, and the game crashed when trying to save it.

Attached is the log file and a save game from just before the crash. If you place a signal immediately after the station, then try to save, the game RIPs.

Windows 10, version 17.54, no mods
Attachments
death 26.2.zip
(12.68 MiB) Downloaded 69 times
factorio-current.log
(8.01 KiB) Downloaded 78 times

AngledLuffa
Fast Inserter
Fast Inserter
Posts: 183
Joined: Fri Jan 05, 2018 5:18 pm
Contact:

Re: [0.17.54] Crash when saving a single train loop with one signal

Post by AngledLuffa »

Weirdly, if you place the signal before the stop, or if you place signals on both sides of the stop, the crash doesn't happen. The crash only happens when the signal is immediately after the stop and there are no other signals on the loop.

kovarex
Factorio Staff
Factorio Staff
Posts: 8058
Joined: Wed Feb 06, 2013 12:00 am
Contact:

Re: [kovarex] [0.17.54] Crash when saving a single train loop with one signal

Post by kovarex »

Thanks for the report, it is fixed for the next release.

These kind of corner cases are the reason I applied the consistency check on save, to figure them all out.

AngledLuffa
Fast Inserter
Fast Inserter
Posts: 183
Joined: Fri Jan 05, 2018 5:18 pm
Contact:

Re: [kovarex] [0.17.54] Crash when saving a single train loop with one signal

Post by AngledLuffa »

Excellent, thank you!

Post Reply

Return to “Resolved Problems and Bugs”