[kovarex] [0.17.52] Crash on saving with specific rail signal placement: "RailSignalBase::checkConsistency"

[Dupl3xxx]

Making this setup and then placing rail signals in the white spots will allow signals to be placed. When the game saves, this causes the game to crash. Both auto-save and manual saving will crash the game. Tested on different systems to be sure. Screenshot of setup and log attatched.

Normal setup, allows for wrong signal placement.


Signals placed in the wrong spot. This causes crash when saving.

[bitbyte]

Possibly relevant to [0.17.50] Signal placement at rail divergence

It appears that the invalid signals be placed in 4 positions, dependent on the curved rail direction.

Valid signals can be placed around it, as expected, but placing one on the same tile appears not to split the train block, and only one of the two signals interacts properly with trains.
The game autosaving appears to crash the game, and result in a partial, corrupted autosave. However contrary to duplex, a manual save appears to complete fine.

[Dupl3xxx]

Re-checked, and I cannot manually save.

[Loewchen]

Ref.: 72630

[kovarex]

Thanks for the report, this is now fixed for the next release.