Configuration
- settings.png (57.61 KiB) Viewed 463 times
For each of the four presets, you can configure the following properties:
Zoom level (in Settings / Mod Settings)
Defines how much (or how little) you can see. Decrease it to zoom out. Be careful with values lower than 0.1 as it might cause performance problems.
To give you an idea of what the numbers mean, these are the values defined by the base game:
- 3 - maximum zoom in (whether on map or not)
- 1 - that's the zoom level that you start with when you load a game
- 0.275 - maximum player zoom out; while on the map, this is the zoom-to-world threshold
- 0.0035 - maximum zoom out on the map
Defines whether the to open (and in which mod) or close a map:
- Player - map closed
- Zoom to World View - map open in world view where interacting with entities is possible
- Map View - map open in the pixelated view (like where you don't have radar coverage)
Default bindings are CTRL + 1, CTRL + 2, CTRL + 3, CTRL + 4 which you can change in the game controls
Known Issues
- Changing from "Map View" to "Zoom to World View" resets the map's position to player's position. This is a limitation in Factorio's modding API which I have already raised to their development team.
- There is similar limitation when changing view type in the other direction (i.e. zooming out to map), however, if you hover over a game entity, the mod will use this entity's position rather than player's position.