When I remove my mod, Whistle Stop Factories, from a save, the map no longer loads and gives the following error, "Corrupt Map: unknown tile 225" when trying to load it without my mod.
Steps to recreate:
* Create a new game with Base and Whistle Stop Factories 0.1.12 (EDIT: With Minimum Distance setting of 10)
* Save game
* Remove Whistle Stop Factories
* Load the game: Get error message "Corrupt Map: unknown tile 225"
EDIT: Tried it again and got a different error message: "Not Enough Data Remaining (wrong count?)"
[0.17.4] Corrupt map caused by removing mod
Re: [0.17.4] Corrupt map caused by removing mod
Post the save, post the log.
Re: [0.17.4] Corrupt map caused by removing mod
Woops, I should've done that from the start.
Attached is the one that gives the "Not Enough Data Remaining (wrong count?)" Error.
Attached is the one that gives the "Not Enough Data Remaining (wrong count?)" Error.
- Attachments
-
- 0Whistle.zip
- (1.14 MiB) Downloaded 91 times
-
- factorio-current.log
- (5.29 KiB) Downloaded 101 times
Re: [0.17.4] Corrupt map caused by removing mod
And here is one that gives me the error "Corrupt Map: unknown tile 40." I'm posting this one here instead of its own thread because it has the exact same reproduction steps.
- Attachments
-
- factorio-current.log
- (5.99 KiB) Downloaded 104 times
-
- 0Whistle2.zip
- (1.09 MiB) Downloaded 93 times
Re: [0.17.4] Corrupt map caused by removing mod
Hello, thanks for the reports.
Both saves load for me in 0.17.6, so I suppose it has been fixed.
Both saves load for me in 0.17.6, so I suppose it has been fixed.