This idea is based on Flamethrower turret(turret which requires fluid to attack) + Metal Gear Ray(contains Hydro Cutter inside of its mouth) from Metal Gear series.
Basically, a turret which requires both water and electricity to work. The idea is about pushing enemies back enough to force them to be unable to attack while player's turrets still can do. You can expect pushing Biters back enough to prevent them from scratching your stone walls or Spitters not being able to attack due to distance problem the turret causes.
Technique: Hydro Cutter Turret - Unlocks a turret you can use to push enemies back with high-pressure water-jet.
└ Requires 150 Science Pack 1, 2, 3, Military Science Packs, and each pack requires 30 seconds.
Item: Hydro Cutter Turret = Steel plate * 20 + Pipe * 5 + Pump * 5 + Electric Engine Unit * 10 + 20 seconds
└ HP: 1,500
└ Energy consumed: 2.4 MW - I think this one doesn't need to be reduced, simply cause it uses water, which needs to be highly compressed enough to do a damage and cause knockback to enemies it strikes.
└ Draining: 5 kW
└ Range: 23 - It should be long enough so that it can hit spitters close enough to spit its acid, or biters closing in and clawing walls. Also since it's blasting its water beam straight towards the enemy there should be no minimum range, though damage should be reduced enough so that it won't become OP for defense
└ Fluid usage: 100 water/second
└ Damage: Maximum 35 damage at the closest range. The damage will be reduced depending on distance, and if distance between turret and enemy is more than 15 the enemy doesn't take any damage but still takes knockback. Enemies located far enough(20 or more) won't be affected at all.
Properties: Hydro Cutter Turret fires off a straightforward water stream which deals damage and causes knockback depending on the distance between turret and the opponent. Beware, though! Stream of water can also damage player as well.
[Idea] Hydro cutter turret
-
- Burner Inserter
- Posts: 14
- Joined: Sat Jul 07, 2018 6:55 am
- Contact:
Re: [Idea] Hydro cutter turret
Now is impossible to make the turret, that needs more then one component: electric energy, ammo, fluid.
May be some compressed air-water-steel-balls capsules, same work as ammo, but need a lot of energy/time to compressing.
May be some compressed air-water-steel-balls capsules, same work as ammo, but need a lot of energy/time to compressing.