[0.16.18] Trains turn around when station is programmed

[GoofyZ]

Hi,

Just want to inform you guy's that i programmed a train stop to enable/disable. When X ammount is reached then green 1 output, + signal hooked up before train station. Then i connected everything and coded the trainstation to enable disable, enabled green = 2.

On the map you can see it turns red or white when station is enabled or disabled. When turned red everything works ok. But when station is enabled the train drives really close to station but then turns around when he is to the closest roundabout. Never seen this happen. The station is White in the map...............

I dont get it, seems like a bug.

When i remove the coding everything works again.

Is it because i use 2 signals on the train station because i have similar one but then only one signal and that one works. But i really want to use 2 signals.

[GoofyZ]

Mmmm wait when the train is not even on the track the signal is still turning red, but the train is not even there. Thats why it closes the train stop for 1 second. I think this should not happen. I will make a youtube.

[GoofyZ]

Never mind, delete the post. I see that you can't do it this way. I figured it out when i was recording.

NOT A BUG, IT WAS JUST ME. SORRY