[kovarex] Belts not properly connecting in blueprints in some cases

[Artentus]

As the title says, I have come across a few (rare) occasions where belts in a blueprint are not properly connected.
Example https://i.imgur.com/OhTVh4P.png

Note that this only occurs while hovering the blueprint with the cursor. Once it is actually placed down the problem does not persist.

[kovarex]

I tried to reproduced it (I created the same blueprint and hovered it) and it worked fine. Could you provide the blueprint string? In that case it would be great if you could test, that new blueprint created from that string has that problem as well.

[kovarex]

Actually, I encountered it in different report ( 54602) (which I just fixed), and I'm 99% sure that it is the same issue.
So I'm marking this as duplicate.