Station does not read train content

[eFieX]

Hi

I am struggling with the Station reading the content of the train.
When i create a blueprint from the provided demo level, place that in my map and let it build by robots the station works.
But when i place down the station manually whenever a train comes into the station the content will not be read.

What am i doing wrong ?
The LTN station has the Lamp, the Ouptut sensor and the Station itself, I connect my constant combinator with a green wire to the lamp, and to my chests.
I connect the output sensor from the station with red wire to the input of my arithmetic combinator this multiplies each with -1.
Then i connect the station to the output of the arithmetic combinator with red wire and then to my filter inserters and set them to set filters.
To check i additionally also put the red wire into an electric pole to check the signal.
No matter what station i make, Provider, Requester or Depot the train content will not be read.

What am i missing ?

[Optera]

Did you check "read train contents" at the stop?

[eFieX]

well that was embarrassing, you are absolutely right that was the problem

thanks