Please allow fresh blueprints to stack in inventory

[psychogears]

Suggestion: please consider allowing fresh blueprints to stack in inventory.

Thanks.

-T

[sillyfly]

This sounds reasonable, but could lead to a problem if your inventory is full - the newly-assigned blueprint will have nowhere to go.

Come to think of it, I think there may have been a discussion about it in the forums already...

[psychogears]

Regarding the case of the full inventory, wouldn't just dropping it on the ground be a feasible solution, similar to cancelling a queued manual assembly task with a full inventory?

Apologies if this was already requested. I did a quick search and didn't see a thread specifically requesting this suggestion.

-T

[bobingabout]

I think the suggestion is a little redundant, because blueprints are being replaced with a blueprints book, they all get stored within this item.

[Koub]

I think the suggestion is a little redundant, because blueprints are being replaced with a blueprints book, they all get stored within this item.

As bob says. The blueprint book is expected with next major version (0.13)