[Dominik][0.17.60] Fluid mixing by pipe upgrade [mods]

[boskid]

1. Download "fluid-mixing-by-upgrade", sync mods then load
   save

   fluid-mixing-by-upgrade.zip

   (177.58 KiB) Downloaded 128 times

   

   fluid-mixing-by-upgrade.png (52.43 KiB) Viewed 2229 times

2. Remove cutter underground pipe
3. Use upgrade planner(is in toolbar) to instant upgrade pipe that is in front of assembler

4. 

   fluid-mixing-by-upgrade-2.png (48.28 KiB) Viewed 2229 times

[boskid]

Because upgrade of undeground pipe (in setup from first post) will mark underground pipe to be upgraded by bots, i had to come up with more complex setup:

1. Download "fluid-mixing-by-upgrade-of-underground-pipe", sync mods then load
   save

   fluid-mixing-by-upgrade-of-underground-pipe.zip

   (185.66 KiB) Downloaded 127 times

   

   fluid-mixing-by-upgrade-of-underground-pipe-1.png (54.44 KiB) Viewed 2220 times

2. Remove cutter underground pipe
3. Upgrade second from left underground pipe (it is connected to two fluid entities from same fluid system)

4. 

   fluid-mixing-by-upgrade-of-underground-pipe-2.png (53.18 KiB) Viewed 2220 times

[Dominik]

Resolved this by preventing the action altogether if the blocked connection is in play. See viewtopic.php?f=182&t=73884 for more.

[boskid]

Steps to reproduce:

1. Build this:

   

   steam-engine-to-steam-turbine-fluid-mixing.png (65 KiB) Viewed 2137 times

2. Remove cutter
3. Upgrade (by upgrade planner or by hand) steam engine into steam turbine
4. Fluid mixing (crashes on consistency check)

And another case, bundled with gui crash: 73926

[Dominik]

I have blocked upgrading anything that has a fluid system with the block.