[1.1.35] Failed to save; crash when loading autosave

Post your bugs and problems so we can fix them.
Post Reply
lnature
Manual Inserter
Manual Inserter
Posts: 1
Joined: Thu Jul 15, 2021 10:21 pm
Contact:

[1.1.35] Failed to save; crash when loading autosave

Post by lnature »

I was doing some nice building when I decided that I came to a substantial progress that I wanted to do a full save (non-autosave).
I ran into the following error upon attempting to save:

Code: Select all

Saving scenario failed: ElectricNetworkSerialiser::getEnergySourceIndex, the energy source was not saved.
Upon attempting to load all three autosaves, I ran into either crashes or the following error:

Code: Select all

Invalid SignalID type: 240
I did quite a lot of tasks, so I can't give a hardcore answer as to why the issue happen.

Unfortunately, there is no other information that I can provide except that I happened to install Rate Calculator after my save yesterday. I can provide the working save if needed, but the playtime difference is 3 hours. Other than that, no other mods have been used/installed beyond the above's dependencies.
Attachments
_autosave3.zip
(9.55 MiB) Downloaded 78 times
_autosave2.zip
(9.2 MiB) Downloaded 78 times
_autosave1.zip
(9.49 MiB) Downloaded 76 times
factorio-current.log
(12.17 KiB) Downloaded 81 times

Post Reply

Return to “Bug Reports”