I placed a locomotive in world, clicked on it to open the control panel. The GUI for automated travel setup is clipped, which makes it unusable.
The two visible buttons work, but there's no way to switch the train into automatic mode or to manually set the current destination.
My screen resolution is 1366x768, running on Arch Linux.
See attached image:
[16.2] Clipped locomotive GUI when using 500 inventory slots
[16.2] Clipped locomotive GUI when using 500 inventory slots
- Attachments
-
- ikea.zip
- My savefile
- (6.51 MiB) Downloaded 66 times
-
- mods.zip
- Mods
- (397.57 KiB) Downloaded 67 times
-
- factorio-current.log
- Logfile
- (7.87 KiB) Downloaded 97 times
Last edited by kubasz on Sat Dec 23, 2017 8:01 pm, edited 1 time in total.
- TruePikachu
- Filter Inserter
- Posts: 978
- Joined: Sat Apr 09, 2016 8:39 pm
- Contact:
Re: [16.2] Clipped locomotive GUI on 1366x768 resolution
Does the issue persist if you scale down to, say, 80% GUI scale?
Re: [16.2] Clipped locomotive GUI on 1366x768 resolution
Yes, unfortunately it does (80% scale, the minimum that can be set using the slider):
Re: [16.2] Clipped locomotive GUI on 1366x768 resolution
I think I have found the cause of this. It's not the resolution, I got the same clipped gui on my 1080p monitor. However, when not using the 500 inventory slots mod the issue disappears - somehow the additional inv. slots mess up the gui.