Place 22.5 degree track road and a curved rail next to it, intersect it with curved rail.
There are green rectangles for rail signal placement where the signals only blink and do not segment the rail network.
What happened?
Rail signal is only blinking.
What did you expect to happen instead? It might be obvious to you, but do it anyway!
Rail signals to work, since placed on a green rectangle - or not to show the green rectangle, if position is invalid.
Does it happen always, once, or sometimes?
Always in this setup - see yellow signal in the picture and the position bottom-right to it (blinking rail signal needs to be removed first).
Blueprint:
- rail-signal-blinking-only.png (876.21 KiB) Viewed 91 times
