I was trying to extend my main bus. Was in Remote View (all belts were ghosts). Added my new connections to the new build, and was bringing the belts backward to reconnect with the bus.
What happened?
When my new belt connected with the existing belts, it added an underground belt pair.
What did you expect to happen instead? It might be obvious to you, but do it anyway!
It should have just connected up belt to belt.
Does it happen always, once, or sometimes?
Always happens, but only under certain conditions. First, it must be going backward. Second, it must have already gone over another belt. It is a bit hard to put into words, so please see the screen shot.
This is the setup to replicate the problem. Start with the single belt pieces on the right, drag left to connect to the belts on the left. Note that all horizontal belts are facing right.
- 20241103220703_1.jpg (675.72 KiB) Viewed 543 times
- 20241103220710_1.jpg (672.98 KiB) Viewed 543 times
- 20241103220608_1.jpg (679.38 KiB) Viewed 543 times
Note: I did search and found a post that seemed similar, and might have a similar root cause, but there the reproduction steps required that you drag first one way and then back, while this but was dragging in just one direction. viewtopic.php?f=7&t=119080
Lastly, just want to say that I really like this feature, and this is the first bug I have found with it. Thank you again for all your hard work, and so far am loving Space Age. Just reaching space for the first time, and am super excited about it!
