[0.13] Pipe to Circuit Network

saturn7 · Post by **saturn7** » Wed Jun 29, 2016 10:40 pm

One thing that apparently cannot be connected to the circuit network is the pipe.

Incidentally it was the first thing I tried to connect in 0.13

(for balancing the petroleum between plastic and sulfur).

Would be great if that could be added!

Neotix · Post by **Neotix** » Thu Jun 30, 2016 7:13 am

You can connect Tank.

gheift · Post by **gheift** » Thu Jun 30, 2016 7:15 am

Or the small pump to control the flow.

saturn7 · Post by **saturn7** » Thu Jun 30, 2016 12:30 pm

I know, but it would be nice to read out the content of the pipes directly, without the side effect of tanks and pumps.

Post by **ssilk** » Thu Jun 30, 2016 2:37 pm

When I remember right it was on the list of things Twinsen wanted to implement for the circuit network.

soren82002 · Post by **soren82002** » Fri Jul 01, 2016 2:14 am

Joined into this older thread (hum, only one day older) -- ßilk

When working on a circuit network on a server, I noticed that the only way to get a reading on how much liquid we had flowing in pipes was to put down a tank and measure that. Pumps can only be turned on and off, and you can't connect wires to pipes. This doesn't make much sense, because we can connect to transport belts.

Factorio Forums

[0.13] Pipe to Circuit Network

[0.13] Pipe to Circuit Network

Re: [0.13] Pipe to Circuit Network

Re: [0.13] Pipe to Circuit Network

Re: [0.13] Pipe to Circuit Network

Re: [0.13] Pipe to Circuit Network

Piping Circuit Network