[2.0.9] "[virtual-signal=signal-item-parameter]" is not read from the interrupt condition for empty trains

[Hares]

Setup:
Train schedule:

Train schedule

10-24-2024, 16-05-49.png (48.84 KiB) Viewed 148 times

Interrupts - Minimal setup:

Interrupt Load -> Unload, minimal

10-24-2024, 16-00-24.png (42.65 KiB) Viewed 156 times

Interrupt Unload -> Load, minimal

10-24-2024, 16-00-45.png (44.61 KiB) Viewed 156 times

Interrupts - Full setup (different load->unload conditions, allow interrupting other interrupts) - in the save file:

Interrupt Load -> Unload, full

10-24-2024, 16-01-25.png (52.52 KiB) Viewed 156 times

Interrupt Unload -> Load, full

10-24-2024, 16-01-41.png (41.81 KiB) Viewed 156 times

Save file attached.

Steps to Reproduce:

1. Re-create the setup or load the save file (deploy trains to the ore pickup and fill their cargo)
2. Launch any of the trains by switching them from manual mode to automated

Expected:

1. Train is launched by the "Load -> Unload" interrupt
2. When unload is finished, train is sent to the train stop it started from (goes backs and forth between two train stops of the same item type)

Actual:

1. Train is launched by the "Load -> Unload" interrupt
2. When unload is finished, train enters manual mode
3. Train is permanently stopped until manual interference

[Klonan]

Hi,

Thanks for the report,

Unfortunately the generic items dont' work with empty trains in this way, it is a good idea for a future feature

Until then, you can provide a list of all signals with a constant combinator and use that to populate the available signals