How many main bus lines do you generally use?

Post all other topics which do not belong to any other category.
Maddhawk
Long Handed Inserter
Long Handed Inserter
Posts: 94
Joined: Sat May 05, 2018 6:53 am
Contact:

Re: How many main bus lines do you generally use?

Post by Maddhawk » Fri Mar 08, 2019 5:14 pm

Last factory I made ran 22 lines of iron, 2 lines of steel, 4 lines of plastic, 1 pipe of acid and 12 lines of copper. That was for 140 science per minute on yellow belt only. Obviously that would go down if I had cared to try red or blue belts.

FunMaker
Long Handed Inserter
Long Handed Inserter
Posts: 67
Joined: Wed Jun 08, 2016 8:43 pm
Contact:

Re: How many main bus lines do you generally use?

Post by FunMaker » Tue Mar 12, 2019 9:44 am

1 Iron Plates
1 Cog Wheels
1 Green Circuits
1 Copper
1 Green Circuits
1 Cog Wheels
1 Iron Plates

This is only for the bootstrap factory, other materials are feeded as needed and are not built into the bus. While going for oil i build up a train network because conveyors are not ment for high throughput.

Post Reply

Return to “General discussion”

Who is online

Users browsing this forum: No registered users