Turbo belt "imprinted" on screen [2.0.20]

Anything that prevents you from playing the game properly. Do you have issues playing for the game, downloading it or successfully running it on your computer? Let us know here.
_Cosmicc_
Manual Inserter
Manual Inserter
Posts: 1
Joined: Sun Oct 27, 2024 7:02 pm
Contact:

Turbo belt "imprinted" on screen [2.0.20]

Post by _Cosmicc_ »

I think this is the second time now, but when I left my laptop open for a minute or two while I was afk, the turbo belts imprinted themselves on my screen for a minute or two until the disappeared, similar to old tv's whos images would become ingrained into the screen after being left on for too long. I have only seen this happen for turbo belts, but I havent really tested others. This visual effect persisted even when I switched programs on my computer so it is likely something weird happening with my specific visual setup but it has never happened on any other game or anywhere else. I attached my monitor settings as well as my factorio graphics settings I used when this happened. I was on 60 Hz refresh rate when the issue happened (image shows 144 but I changed it after the issue). I also have a RTX 4060, 64Gb of ram, and a 13th Gen Intel(R) Core (TM) i9-13900HX CPU.

After some slight testing this only seems to happen on 60Hz refresh rate and not 144 for me.
Attachments
Gleba belts.jpg
Gleba belts.jpg (2.73 MiB) Viewed 218 times
Close up issue.jpg
Close up issue.jpg (2.17 MiB) Viewed 218 times
Issue.jpg
Issue.jpg (1.83 MiB) Viewed 218 times
Persistant.jpg
Persistant.jpg (1.66 MiB) Viewed 218 times
Display settings.png
Display settings.png (33.48 KiB) Viewed 218 times
Graphics settings.png
Graphics settings.png (179.63 KiB) Viewed 218 times
DarkShadow44
Filter Inserter
Filter Inserter
Posts: 359
Joined: Thu Jun 01, 2017 12:05 pm
Contact:

Re: Turbo belt "imprinted" on screen [2.0.20]

Post by DarkShadow44 »

I assume screenshots don't capture the issues? In this case I assume this is a screen issue, not much factorio can do.
Post Reply

Return to “Technical Help”