I have a working save at 564:13:56 playtime that loads correctly.
I'm able to save normaly once the game is loaded, but after a few minutes any saves manual or automatic causes a crash (see log attached).
the issue is 100% reproducible on my side, and therefore saving is impossible, preventing me from continuing this save.
[1.1.109] Crash on save: "FlowStatistics attempted to save value larger than uint16"
[1.1.109] Crash on save: "FlowStatistics attempted to save value larger than uint16"
- Attachments
-
- factorio-dump-previous.dmp
- (1.39 MiB) Downloaded 21 times
-
- factorio-previous.log
- (98.6 KiB) Downloaded 20 times
-
- Pyblock.zip
- (13.63 MiB) Downloaded 18 times
Re: [1.1.109] Crash on save: "FlowStatistics attempted to save value larger than uint16"
Looks like a bit flip, is it always the exact same error including the value?
Re: [1.1.109] Crash on save: "FlowStatistics attempted to save value larger than uint16"
Newly generated crash log attached. Same everything.
- Attachments
-
- factorio-current.log
- (98.5 KiB) Downloaded 20 times
Re: [1.1.109] Crash on save: "FlowStatistics attempted to save value larger than uint16"
I did some further testing:
- Verifying game files -> ok
- Full re-install of the mods -> same problem
- RAM test of the PC -> test ok
- Loaded my save on the steamDeck -> same problem
- changed the mod config for the save -> same problem with only the full pyanodon suite but no other mods
I think there is a good chance that this is an actual bug. Would it be possible to move this post to the bug section?
- Verifying game files -> ok
- Full re-install of the mods -> same problem
- RAM test of the PC -> test ok
- Loaded my save on the steamDeck -> same problem
- changed the mod config for the save -> same problem with only the full pyanodon suite but no other mods
I think there is a good chance that this is an actual bug. Would it be possible to move this post to the bug section?
Re: [1.1.109] Crash on save: "FlowStatistics attempted to save value larger than uint16"
This specific error means that the value has been corrupted some time in the past. The only other times I've seen it are when the person had bad and or failing hardware (bad RAM is most common). Unless you know of a way to reproduce this error from a fresh save file I'm 99% sure that your hardware is failing even if the memory test didn't catch it this time.
If you want to get ahold of me I'm almost always on Discord.
Re: [1.1.109] Crash on save: "FlowStatistics attempted to save value larger than uint16"
I see.
Since the save is loadable (and even re-savable for a while) is there anyway the file could be "fixed"?
Since the save is loadable (and even re-savable for a while) is there anyway the file could be "fixed"?
Re: [1.1.109] Crash on save: "FlowStatistics attempted to save value larger than uint16"
Potentially, but without fixing the reason it got into that broken state, it will most likely get broken again. It could also be broken in other ways that are not currently being caught.
If you want to get ahold of me I'm almost always on Discord.