[1.1.80] Increasing crafting speed of an assembler does not wake sleeping inserters

[aaargha]

Found that inserters are not woken up when the output limit of an assembler changes due to the crafting speed increasing.

This (or very similar) has already been reported here and marked as resolved, but the issue seems to exist in 1.1.80

Screenshot showing the issue using the show-active-state debug option

sleepy_inserter.png (120.29 KiB) Viewed 732 times

Use the blueprint below to reproduce, it should craft iron gears until full (inserter sleeps at 4). Adding the four speed-3 modules should make the machine craft more until the new limit of 10, but nothing happens.

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

Copy blueprint

[Rseding91]

Thanks for the report. That original issue was reverted due to a desync it caused. Currently that is simply an unfortunate interaction with module effects and crafting machines. Realistically it doesn't matter because nothing is removing those items so crafting more right then isn't important. As soon as anything removes the output inventory contents it will resume work with the new overload value(s).