[1.1.33] Desync when inserting modules into beacon

[TheEdgeOfRage]

I have a green circuit assembler setup that has some beacons around it. When inserting speed modules into those beacons I sometimes get a server desync. It's not consistent and more often than not I can insert the modules just fine, but sometimes it desyncs me. It happens only in that one specific layout of beacons next to the assemblers. In the save file there is only one place where green circuits are created, that one triggered the desync.

I don't know whether the layout of the beacons in relation to the assemblers is the problem, or the fact that the setup has been blueprinted, and so the beacons have the missing module blue status icon. Since inserting module into those with the missing module warning caused the desync. Hopefully this is enough to reproduce it. If not, I can try setting up a minimal save that can hopefully increase the chances of it happening.

I have three desync reports from the times when it happened and tar-ed them into a single file.

https://share.theedgeofrage.com/desync.tar

[boskid]

Sounds like 98445

-- edit:
which should be fixed in 1.1.34