What did you do?
- Create a blueprint/blueprint book with rich text tags where the end tag would be cut off due to truncation
What happened?
- The beginning part of the tag is displayed and whatever text was afterwards
What did you expect to happen instead? It might be obvious to you, but do it anyway!
- The color tags should potentially be bumped forward so they properly terminate, or they should be stripped altogether so that the text can still be read.
In the screenshot the blueprint named 'Linear x 8' has the color yellow and because it is short enough it works fine. The one called 'Tessellate x42' however is too long, and the color tag shows up and is flowing over the other blueprint and it isn't properly truncating/abbreviating. Without color the blueprint will abbreviate just fine. If whatever tags were started in the text could be ignored, and then properly terminated after the truncation it would look potentially better.
[Wheybags] [0.17.33] Rich text tags break in blueprints
[Wheybags] [0.17.33] Rich text tags break in blueprints
- Attachments
-
- factorio-current.log
- (15.92 KiB) Downloaded 101 times
-
- Manually truncating the text to show what it could look like
- Color Tag Suggestion.png (41.26 KiB) Viewed 1451 times
-
- Removing the color tag shows what the abbreviations should look like
- Uncolored Tag.png (117.1 KiB) Viewed 1451 times
-
- With the color tags the text is jumbled (this is current state)
- Color Tags.png (383.2 KiB) Viewed 1451 times
Re: [Wheybags] [0.17.33] Rich text tags break in blueprints
Duplicate of 69917 (same problem, different gui)
Thanks for the report anyway!
Thanks for the report anyway!