The problem occurs when you have a full compressed underground blue belt.
Belt Belt UGBelt StackInserter Assembler
Product Direction ---->
In that configuration the stack inserter is picking up from the belt and loading the assembler. It will periodically get "stuck" and won't pick up any items. Sites this way for 5 - 6 seconds then resumes operation, works for awhile and gets stuck again. If the belt is not 100% compressed it doesn't appear to cause an issue.
[16.25] Stack inserters stuck trying to pick up items
Re: [16.25] Stack inserters stuck trying to pick up items
It may be the same issue, but that one is talking about the far side of the exit end. This is a full compressed close side of the entrance end. Does that make a difference?
Not sure it's the same issue.
Are you sure it should be in duplicates?
Not sure it's the same issue.
Are you sure it should be in duplicates?