After placing a blueprint and building not all power poles the wire connections will stay with the blueprints even though they could connect directly.
reproduction, place the following blueprint:
0eNqVkdFqhDAQRf/lPmeXGlfU/EqRonbYDsSJJHGpSP59jaVQWCj4OMPMOcydDYNdaPYsEWYDj04CzPuGwHfpbe7FdSYYcKQJCtJPuQpTb+2FLI3R83iZnSUkBZZP+oYpUqdAEjky/eCOYv2QZRrI7wP/ghRmF/ZdJ9mfedW1UlhhdHmtdo0Q378Gt/gML7ukXgT6nEDrs4Ly5AXtr6B+FRRKdzmxI2Lz5yMKD/LhoOimuNWtrhvd1m9Nm9ITzwWRjQ==
build the left and right power pole. The wire goes from both to the blue print, but does not connect the two poles.
problem: no power connection.
My expectation is that if a working power line is possible a ghost image should not interfere with it.
this is similar to the following reports:
viewtopic.php?f=23&t=106040&p=584571&hi ... st#p584571
viewtopic.php?f=11&t=91933&p=523462&hil ... re#p523462
[1.1.101] placed power poles do not connect in partly built blue print
Re: [1.1.101] placed power poles do not connect in partly built blue print
Thanks for the report however that is working as intended. Blueprints remember the electric pole connections and will always use those when built.
If you want to get ahold of me I'm almost always on Discord.