Unique Train ID signal is emited when train is not aligned

[mrvn]

The train was stopped at a station with "enable if T = 0" with the new train ID signal and all other stations disabled. Due to the train stuttering bug (see my other bug report) the train leaves the station and then stops and goes. The problem now is that every time it stops the T signal is emited, even with the train half way across the station. The wagons are not aligned for unloading and the second wagon might even be overlapping where the first would be unloaded. I my case it was a single car station so nothing bad happened other than the repeated T signal messing up the circuits. Imho the T signal should only be emited when a train stops properly at the station, not just it stands still near it.

[Twinsen]

I believe solving this problem has no value. It's a glitch caused by a silly circuit network setup. What is your use case?

[Twinsen]

Further discussion and a possible solution was mentioned here: viewtopic.php?f=23&t=47911
please continue the discussion there.