it seems that the algorithm which connects poles to each other doesn't quite produce the same results in all cases.
I built the poles in the following junction manually. As you can see on the screenshot, one of the poles stays disconnected from the large central pole, despite them all being the same distance from it :
- poles-one-disconnected.jpg (859.61 KiB) Viewed 1624 times
1) adding and removing the disconnected pole does nothing.
2) If I remove the disconnected pole and one of the connected poles, then place the same pole in the exact same spot, where the disconnected used to be, it connects to the central pole. Then, if i manually place the last pole on the same spot where the previously connected one used to be it doesn't connect.
3) If i remove the central pole and add it back manually, the poles connect properly.
4) Finally, If i just copy it and put it on a different spot via blueprint, all of them connect properly:
- poles-all-connected-via-bp.jpg (754.44 KiB) Viewed 1624 times
Here's the BP I used :
I don't use any mods.
