[0.17.63] Pump does not connect to fluid wagon if the Train Stop is around a curve
-
Legendendear
- Manual Inserter
- Posts: 4
- Joined: Tue Jun 25, 2019 11:04 am
- Contact:
[0.17.63] Pump does not connect to fluid wagon if the Train Stop is around a curve
Please take a look at the picture below
- Attachments
-
- Here is the problem:
The pumps are not able to connect to the fluid wagons even though the pumps are on the straight railway.
That bug only occures if the train station is behind a curve. - Screenshot (40).png (3.56 MiB) Viewed 1160 times
Re: [0.17.63] Pump does not connect to fluid wagon if the Train Stop is around a curve
Hello, thank you for taking the time to post the bug report, however this is intentional due to complicated graphics of pump connector, it won't connect to fluid wagons unless they are aligned to particular position and train stopped on curve doesn't have correct alignment.
-
Legendendear
- Manual Inserter
- Posts: 4
- Joined: Tue Jun 25, 2019 11:04 am
- Contact:
Re: [0.17.63] Pump does not connect to fluid wagon if the Train Stop is around a curve
Yes I was aware of the fact, that the pump is not connected if the fluid wagon is on a curve. However I didnt know that they wont connect if any part of the train is standing inside a curve. I thougt my problem was not intended...posila wrote: ↑Thu Aug 08, 2019 5:51 pm Hello, thank you for taking the time to post the bug report, however this is intentional due to complicated graphics of pump connector, it won't connect to fluid wagons unless they are aligned to particular position and train stopped on curve doesn't have correct alignment.
