Destination full?

[Florah]

I just started trying out LTN and there is a weird problem that I can't seem to fix. I set up some depot stops and put some trains in them. I then set up a station that provides iron ore and a station that requests it, and that works perfectly. LTN sends my trains from one to the other to pick up stuff and drop off stuff. Now I did exactly the same requester / provider setup for iron plates. An empty train will go to the iron plate provider station, which has loads of iron, but as soon as it arrives, it shows the message "Destination full", and the inserters will not load the train at all. When I turn it into manual mode it immediately starts loading. When I press the button to have it go to the next station, it does so and unloads there, so it is reachable. I just can't figure out why it won't load, since I think I set it up exactly the same as the iron ore station. I just started LTN today, so I probably missed something important, but any help is appreciated.

Screen Shot 2020-12-04 at 23.39.35.png (3.28 MiB) Viewed 30349 times

[Optera]

That's vanilla max trains and has nothing to do with LTN.

[Florah]

Can you tell me how to fix it? Why won’t it load?

[Nosferatu]

Check the next station. Has it been set to allow a maximum of trains?

[Florah]

I don't think so! This is the next station. When I set the "Enable train limit" thing to 20, still nothing happens.
But even if the station was full, the train would still load at the current station, right? I just don't understand why the inserters are doing nothing

Screen Shot 2020-12-05 at 10.31.27.png (853.01 KiB) Viewed 30301 times

[Florah]

OMG I found it, it was a really stupid mistake. Somehow the current stop was set to a train limit of 0, but I didn't see it because trains would still go there, they just wouldn't load... Thanks so much for the help!

[grovepjp]

tx