Hello. Pictures are worth a thousand words. In short, the condition on the inserter is logi-bots > 0, there are 977 in the network with 350 being in the adjacent roboport.
Why isn't this lognet inserter enabled?
-
- Fast Inserter
- Posts: 152
- Joined: Fri Aug 12, 2016 10:22 pm
- Contact:
Re: Why isn't this lognet inserter enabled?
Robotport slots cannot be counted. Vote to change that here.
The total robots in the network can be counted, if you connect a wire to the roboport and use the circuit condition.
The total robots in the network can be counted, if you connect a wire to the roboport and use the circuit condition.
Re: Why isn't this lognet inserter enabled?
How many robot slots the roboport have? Is it full?
-
- Fast Inserter
- Posts: 120
- Joined: Wed Aug 10, 2016 2:53 pm
- Contact:
Re: Why isn't this lognet inserter enabled?
Because there is NO robots in a LOGISTIC network (logistic CHESTS). If you want to see how many robots are FLYING (or sitting in roboports) you should use wire to roboport and read contents of the robot network (open the wired roboport interface and switch mode of network).doktorstick wrote:Hello. Pictures are worth a thousand words. In short, the condition on the inserter is logi-bots > 0, there are 977 in the network with 350 being in the adjacent roboport.
-
- Fast Inserter
- Posts: 152
- Joined: Fri Aug 12, 2016 10:22 pm
- Contact:
Re: Why isn't this lognet inserter enabled?
I didn't know you could change that circuit mode of a roboport, thanks.