I have a problem where I had setup a pipe network and now have changed my mind as to the fluid a particular set of pipes should carry. Problem is that I can't figure out how to completely empty the pipes and re-use the same pipe network. Is my only recourse to delete all the pipes and re-construct them?
Any tips on how to do this?
How to empty pipes already assigned to a fluid/gas?
-
wobbycarly
- Filter Inserter
- Posts: 267
- Joined: Tue Jan 29, 2019 4:00 am
- Contact:
I agree this is a bit of an issue with the way pipes are "assigned" a fluid.Re: How to empty pipes already assigned to a fluid/gas?
If the pipes are empty, remove or unassign all sources feeding into the pipes and all destinations consuming from the pipes. Then build new sources and destinations. (This step is new for 0.17)
If the pipes aren't empty, pump the fluid into a tank, or just delete all the pipes. Then note that the pump is a destination consuming fluid, and see the first step. (This step is exactly the same as it was in 0.16.)
If the pipes aren't empty, pump the fluid into a tank, or just delete all the pipes. Then note that the pump is a destination consuming fluid, and see the first step. (This step is exactly the same as it was in 0.16.)
Re: How to empty pipes already assigned to a fluid/gas?
From my experience, pumping out the fluid is hit or miss, and the only way to be sure is to rebuild the entire pipe network.