Sometimes when items travel on a belt, the items seem to want to go a little faster, and end up stretching out (see the attached videos, and saves). This seems to happen after copy-pasting from a belt that has a wire connected to it. If I copy-paste from a 'fresh' belt that has just been placed down, and has never seen a wire, then it gets fixed after a some time passes.
I turned on the show-transport-lines debug option, and it gives me one long transport line for the normal behavior (see normal.png), and a whole bunch of small transport lines for the weird behavior (weird.png). Perhaps that's the problem?
[0.16.20] Items on belt stretch after copy pasting
[0.16.20] Items on belt stretch after copy pasting
- Attachments
-
- transport-lines before copy-pasting
- normal.png (455.94 KiB) Viewed 1505 times
-
- transport-lines after copy-pasting
- weird.png (487.99 KiB) Viewed 1505 times
-
- weird.webm
- weird behavior
- (7.32 MiB) Downloaded 76 times
-
- normal.webm
- expected behavior
- (7.07 MiB) Downloaded 63 times
-
- beltStretching postpaste.zip
- Test setup save after copy-pasting.
- (192.48 KiB) Downloaded 61 times
-
- beltStretching prepaste.zip
- Test setup save before copy-pasting.
- (185.27 KiB) Downloaded 70 times
-
TruePikachu
- Filter Inserter
- Posts: 978
- Joined: Sat Apr 09, 2016 8:39 pm
- Contact:
Re: [16.20] Items on belt stretch after copy pasting
To confirm, when you say copy/paste, you are referring to the blueprint functionality, and not some mod, correct?
Re: [16.20] Items on belt stretch after copy pasting
I meant the copy entity settings, Control right-click (copy) and control left-click (paste).TruePikachu wrote:To confirm, when you say copy/paste, you are referring to the blueprint functionality, and not some mod, correct?
There are no mods involved.
Re: [0.16.20] Items on belt stretch after copy pasting
This was fixed already, thanks for the report though.