Ctrl-Click for manual temp. station movement does not work

[wat3rstone]

When opening a train's gui and trying to ctrl-click to a location, one of 2 things happen, either it will temporarily turn of the current station the train is at, or it will count for it's temporary timer at the station it is standing at and then it will 'return' to its station. In both cases, the train doesn't move from it's station and temporarily turns of the station.

Screenshot (34).png (995.98 KiB) Viewed 3725 times

train acts like it is travelling to the temp. station but never moves

Screenshot (35).png (998.92 KiB) Viewed 3725 times

station temporarily disabled

No mods are being used, and the train does successfully plot a destination (the green line does connect the train to the cursor).

[csduff]

I'm having this problem too.

But, if I CTRL-Click two locations, it waits 5 seconds, as per the condition like it is at the first temp station, then proceeds to the second location that was assigned.

[kovarex]

Thanks for the report, fixed for 0.17.15. (The logic is tricky enough to make stupid mistakes like this, so i started writing tests for these cases to avoid breaking it again)