[0.15.16][Twinsen] Inserters do not update circuit net properly

[chrisgbk]

inserter circuit.png (149.62 KiB) Viewed 853 times

Code: Select all

0eNqVk9FugzAMRf/Fj1OYgJZt4mE/MlUogNdaggQZU7Wq8u9LgrqitVu7l0qu8fU913CCuptwYDIC5QmosWaE8uMEI22N7sJ/chwQSiDBHhQY3YdKM8muR6EmaWxfk9FiGZwCMi0eoMycuqsRdok2clshdxsFaISEcLYUi2Nlpr5G9ivumFEw2NFPWxMcHOLAEcokfS78lpYYm7m5VsGKsO2qGnd6T37YT1xUK99uo9IYGmffUKYK7ICsZx14Aueilpml49NZ+GFslwjkq5XbOBdS+oGV/5nPFVQyU6UPIX1SJ8gPHZjYmmTotCBEpinwZov7bn5B3TKieRR2ddlnRmRv7pow/Qa8hdQQNxPJ5UQzJ49S/ZNwcVQf+KA5Bl7C+3+u6hM6O4pleIlvJpLHRHw3mioXn6GCvb9RJHlZr/OiKN7S7NW5L83/QgI=

In this simple setup, a constant combinator outputs IRON=1 over green, the inserters enable condition is set to IRON>0 and is connected to the constant combinator with green, and the inserter is additionally connected to the input of another combinator with red. If you remove either the green wire, or the constant combinator, the inserter does not update it's enabled condition, even though there is no longer a signal being sent to it, and it will remain enabled forever. Or, at least until you modify the red wire network, or attach to a new green wire network. Seems like it ignores that it was disconnected from the first network.

[Twinsen]

Related to viewtopic.php?f=30&t=48876

Fixed in Version: 0.15.17. Thanks for the report.