[0.14.22] signal flashing on crossing with corner

This subforum contains all the issues which we already resolved.
TheUnknown007
Fast Inserter
Fast Inserter
Posts: 129
Joined: Sun May 03, 2015 9:17 pm
Contact:

[0.14.22] signal flashing on crossing with corner

Post by TheUnknown007 »

See also test map.

step 1: make a crossing with one rail from bottom left to top right (so diagonal) and one from bottom to top (vertical)
step 2: place a signal on the diagonal rail, left from but as close to the vertical rail as possible
step 3: place a corner on the diagonal rail, as close to the signal as possible, from bottom left to right (going from diagonal to horizontal). The signal starts flashing, because it is too close to the corner
step 4: remove the corner. Signal keeps flashing: bug!
Attachments
_bug_corner_signal.zip
test map
(513.04 KiB) Downloaded 165 times
aaargha
Filter Inserter
Filter Inserter
Posts: 333
Joined: Wed Dec 07, 2016 8:35 am
Contact:

Re: [0.14.22] signal flashing on crossing with corner

Post by aaargha »

Seems similar to the issue I've ran into. See picture.
It seems like adding the curved rail makes the whole contraption one big block and it stays that way even after removing it.
To fix the issue you need to replace the chain signal. Also it's not possible to place a signal in the offending possition if the rail is already built so the signal should probably block construction of the rail, no?
Attachments
Christmas is early
Christmas is early
broken signals.png (1.16 MiB) Viewed 5859 times
Rseding91
Factorio Staff
Factorio Staff
Posts: 14345
Joined: Wed Jun 11, 2014 5:23 am
Contact:

Re: [0.14.22] signal flashing on crossing with corner

Post by Rseding91 »

Fixed for 0.15.
If you want to get ahold of me I'm almost always on Discord.
Post Reply

Return to “Resolved Problems and Bugs”