[0.14.19] [Twinsen] belt moves even with contition not fullfilled

[gheift]

I have connected a belt to a pole and set a condition to stop it if a specific item is on it. But the items on the belt moves forward even if the belt is stopped. I could reproduce a small testcase and it looks like the build order is important.

moving-belt-1.png (305.99 KiB) Viewed 5134 times

moving-belt-2.png (324.88 KiB) Viewed 5134 times

moving-belt-3.png (330.21 KiB) Viewed 5134 times

moving-belt-4.png (352.58 KiB) Viewed 5134 times

[kinnom]

the way you've set it up enables the belt when there are circuits on it. NaB

[gheift]

No, the belt should be disabled, if there is a circuit on it. When a circuit enters the belt, the animation stops, but the circuit still moves forward. In this state no new circuit enters the belt, only if the current one leaves the belt, the next one enters.

[kinnom]

I misunderstanded the OP, my bad

[Twinsen]

Something fishy is happening indeed. Thanks for the save, looking into it.

[Twinsen]

Fixed in Version: 0.14.20.

Thanks for the minimal test case save file, it was very helpful.

[gheift]

I have another save. Looks like if the belt with the circuit is directly connected to an underground belt on its left site, the underground belt "sucks" items from the stopped belt if an item travels inside the underground belt.

Edit: Damn, too late…

Thanks for fixing!

[Twinsen]

Loaded the second save and everything seems to work fine.