[boskid][2.0.8] Wire not propogating signal to pole after copy/paste

[isaac868]

I dont know the exact sequence I used to create this issue, but I did replicate it once. Essentially I had few rows of chests, each with a requester and passive providers in an alternating sequence. The requesters were set to "set requests" and wired together within the column with green wire. The providers were unwired. I wired the first column of passive providers with red wire then copied that over to the other columns. I then wired the first passive provider to a pole expecting to see it's contents, but saw nothing. The only console commands I'd run on the save were /editor and /cheat, I've attached the save file, the issue is visible on the pole beside the biter display, the circuit network in question is 181.

[isaac868]

Okay, I think I found the issue. When a requester that is set to "set requests" is shift right clicked then shift left clicked on to a passive provider, that passive provider will no longer output it's contents to it's connected circuit network, unless the "read contents" checkbox is unticked and reticked

[boskid]

Thanks for the report. Issue is now fixed for 2.0.10, there is also a migration that should fix existing entities and there are tests to make sure this never happens again.