[Rseding91] [1.1.70] Some blueprints cropped in bp editor (new bp only)

[JasonC]

I ran into a blueprint that was cropped by the editor window. I've never seen this happen, usually the scaling and centering is correct. Not sure what the cause is; maybe the pipes aren't being included in the size calculation? But that wouldn't expain why the chemical plant in the image below is a little to the left of center.

0eNqdlO9ugyAUxd/lfoamImj1VZZmsUpbMgXjv8w0vvsuNVnXDUf1GxjOz5NzD9zgVPaybpTuIL2Byo1uIX27QasuOivtt26sJaSgOlkBAZ1VdpdfZaXyrKR1maF0IqB0IT8hDSbiFdeqlrQz9NKYXhc/xGw6EpC6U52Ss437ZnzXfXWSDdKfGEisTYuHjbb/QgDl+50gMOIq4DsxWTO/EGzJxr8wgTAChWpkPp/gDnT4OjpMnnw+oSMHmq9AH5bRzIEWvkzD2JdptCnT0A2Ll0rmcBZ9w9ifARHAtbrX7yqzYaRGlTRvsvxD6QvCbCdbS5LnsxUNaIJWpuhLlIQuZ4dNQwheqU7iHcIDuHfnFuxXDHKJ4b1gofAymJfBvYw1V4mvizrgW9qavIQWWxqSLGQQbcngDjvO7Ubl43UnMMimnV+BQ8DjhMURiwSPsepf2fXsew==

Copy blueprint

Yields:

Image1.png (197.53 KiB) Viewed 1532 times

What I did:

1. Activated blueprint tool in game
2. Selected some stuff I already had placed

Expected: New blueprint window with entire selection scaled and centered to fit in editor view.

Actual: Left side is cropped off in editor view.

Note: This is in the initial new blueprint window. Once I saved the blueprint then opened it again, the problem no longer appeared. However, when I again created a new blueprint and selected these objects, the same issue appeared.

[Genhis]

I can't reproduce this issue. Can you share more information (save file + video)?

[WarNerv8]

I can reproduce this issue consistently in 2.0.30. I have been able to do so since the 2.0 release.



If I remove part of the blueprint it re-centers.



It happens with all blueprints I make.

[Muche]

Ref 122927 Blueprint content preview offset, 125931 Blueprint preview with specific blueprint appears initially off-center.

[Rseding91]

Thanks for the report. This is now fixed for the next release.