Page 1 of 1
[1.0.0] blueprint breaks power lines
Posted: Sat Aug 22, 2020 2:29 am
by Mazeru
occasionally when [shift] placing blueprints over existing power poles it disconnects the wires from the poles.
- power.jpg (141.77 KiB) Viewed 2706 times
after placing blueprint
- power 2.jpg (95.25 KiB) Viewed 2706 times
Re: [1.0.0] blueprint breaks power lines
Posted: Sat Aug 22, 2020 3:14 pm
by valneq
Shift+click on a power pole is a shortcut to disconnect all copper wires from that power pole. Shift+click a second time to also disconnect all signal wires.
Maybe the game sometimes registers this shortcut instead of force-placing the blueprint?
Re: [1.0.0] blueprint breaks power lines
Posted: Sat Aug 22, 2020 5:19 pm
by steinio
Not only sometimes. It's always happening if I need to shift build a blueprint and the mouse is hovering over a power pole. (grid based rails etc.)
Decon the pole first solves it temporarily.
Re: [1.0.0] blueprint breaks power lines
Posted: Sat Aug 22, 2020 5:35 pm
by Loewchen
You might be able to change the keybinding for one of the functions.
Re: [1.0.0] blueprint breaks power lines
Posted: Thu Aug 27, 2020 9:51 pm
by kovarex
Well, lot of functions are disabled when holding a blueprint, and this one should probably be among them.
Re: [1.0.0] blueprint breaks power lines
Posted: Fri Aug 28, 2020 12:51 am
by kovarex
Actually, it is a duplicate of a bug I just fixed:
87695
Re: [1.0.0] blueprint breaks power lines
Posted: Sat Sep 05, 2020 10:24 pm
by Mazeru
Thanks