Page 1 of 1
[Dominik][0.17.4] Replacing pipe replaces whole line with fluid of diffrent type
Posted: Sun Mar 03, 2019 8:12 pm
by azureblaze
Right pipe connected to petroleum, currently empty.
Left pipe full with water.
When the horizontal pipe-to-ground of the petroleum L joint is placed by the vertical pipe-to-ground for water, the whole water line turned into petroleum.
Alchemy, way better than chemistry.
save file attached.
Re: [0.17.4] Replacing pipe replaces whole line with fluid of diffrent type
Posted: Sun Mar 03, 2019 8:34 pm
by Loewchen
Can reproduce, the full water pipeline becomes full petroleum gas pipeline.
Re: [Dominik][0.17.4] Replacing pipe replaces whole line with fluid of diffrent type
Posted: Mon Mar 04, 2019 12:00 pm
by Dominik
It actually does not change the fluid - water is still there, but it would somehow wrongly assign the fluid to the system as whole and then show it wrong. Will look into it, thanks.
Re: [Dominik][0.17.4] Replacing pipe replaces whole line with fluid of diffrent type
Posted: Mon Mar 04, 2019 12:54 pm
by Dominik
Re: [Dominik][0.17.4] Replacing pipe replaces whole line with fluid of diffrent type
Posted: Tue Mar 05, 2019 9:50 am
by Dominik
The issue was similar to the linked topic, but in this case I have changed the rules so that it is no longer possible to replace an orthogonal pipe. Thanks for help!