[0.15.14] [Harkonnen] Speaker condition reset when changing instrument
Posted: Fri May 26, 2017 1:08 pm
When the speaker is set to trigger a sound when a circuit network condition is met, changing the instrument resets the condition to the one saved before the Gui was opened.
Example:
Happened to me on 0.15.12, upgrading to 0.15.14 didn't fix it.
I tried to make a gif of it with Gif Screen Recorder but the popup handling is a mess. Any recommendation in case I need to fill a new bug report?
Example:
- speaker.png (91.2 KiB) Viewed 3132 times
- The speaker is set to raise a sound when steam is below 6k
- Open the GUI and change 6k to 7k
- Change the instrument (not the "note" or sub-instrument! That works fine)
- The condition was changed back to 6k.
Happened to me on 0.15.12, upgrading to 0.15.14 didn't fix it.
I tried to make a gif of it with Gif Screen Recorder but the popup handling is a mess. Any recommendation in case I need to fill a new bug report?