Page 1 of 1
[2.1.11] Clicking on a circuit condition while CTRL-C, CTRL-X, etc, has been pressed puts that icon in the criteria box
Posted: Sun Jul 19, 2026 7:28 pm
by nailfoot
Picture should be self explanatory!
- Screenshot 2026-07-19 152129.png (127.85 KiB) Viewed 254 times
Re: [2.1.11] Clicking on a circuit condition while CTRL-C, CTRL-X, etc, has been pressed puts that icon in the criteria
Posted: Sun Jul 19, 2026 8:03 pm
by boskid
I am not seeing anything broken here. Cut tool is an item (even if its cursor-only item), and as such it is a valid signal to appear on a circuit wire and be used inside of conditions.
Re: [2.1.11] Clicking on a circuit condition while CTRL-C, CTRL-X, etc, has been pressed puts that icon in the criteria
Posted: Sun Jul 19, 2026 10:09 pm
by nailfoot
My mistake. It doesn't seem to me that copy, cut, etc, are valid criteria since I did not see them as a selectable signal. Just created a bit of confusion when I clicked there after hitting ctrl-X.
Re: [2.1.11] Clicking on a circuit condition while CTRL-C, CTRL-X, etc, has been pressed puts that icon in the criteria
Posted: Sun Jul 19, 2026 10:18 pm
by nailfoot
If you click a constant combinator with CRTL-X, then that signal is not put in as criteria. So there are some inconsistencies.
Re: [2.1.11] Clicking on a circuit condition while CTRL-C, CTRL-X, etc, has been pressed puts that icon in the criteria
Posted: Sun Jul 19, 2026 11:22 pm
by Rseding91
nailfoot wrote: Sun Jul 19, 2026 10:18 pm
If you click a constant combinator with CRTL-X, then that signal is not put in as criteria. So there are some inconsistencies.
- 07-19-2026, 19-22-51.png (67.03 KiB) Viewed 168 times