Factorio Forums

Posted: **Sun Jun 21, 2026 11:07 am**

Any device (inserter, assembler, belt, etc) connected a circuit network will show what ID they are connected to... except power poles.
If you are trying to make a compact setup with wires going to and fro it would be nice to know what network a power pole is actually connected to.
Or more like, is there a real reason not to show it? Is the code not fit to handle it?

: ID shown on inserter; grafik.png (31.78 KiB) Viewed 381 times

: ID not shown on power poles; grafik.png (178.42 KiB) Viewed 381 times

Posted: **Sun Jun 21, 2026 7:29 pm**

see also 123661

Posted: **Mon Jun 22, 2026 4:01 pm**

sben wrote: Sun Jun 21, 2026 7:29 pm see also 123661

So apparently, the forum gives different results when you search "power poles netowrk" vs "power pole network" with the former yielding way more results, since apparently the search uses exact words and not just "contains" matches.
Fair enough, my fault.

Posted: **Tue Jun 23, 2026 11:12 am**

This is added in 2.1.

Factorio Forums

Power Poles should show Circuit Network ID

Power Poles should show Circuit Network ID

Re: Power Poles should show Circuit Network ID

Re: Power Poles should show Circuit Network ID

Re: Power Poles should show Circuit Network ID