Page 1 of 1
Allow quality range conditions in circuit conditional GUIs
Posted: Tue Sep 30, 2025 10:36 pm
by protocol_1903
TL;DR
Allow the quality range setting seen on inserter and splitter filters to be used in circuit control GUIs, like decider and arithmetic combinators, enable/disable circuit settings, etc.
What?
I would like to use the :any-quality:, >, <, =, >=, <=, ~= quality evaluators inside of signal evaluation conditions like those found in combinators. GUI example:
- Untitled123.png (53.29 KiB) Viewed 189 times
Why?
I want to be able to evaluate multiple qualitied signals simultaneously. While I can do this using selector combinators, having 'inline' per se support would make certain operations a lot cleaner, and it would help some composite entities I'm designing that need to deal with quality in very specific ways
Re: Ability to send quality signals for "set filter"
Posted: Sat Oct 04, 2025 7:35 am
by Koub
[Koub] Merged into an older thread with the same suggestion.
Re: Ability to send quality signals for "set filter"
Posted: Sat Oct 04, 2025 10:38 am
by protocol_1903
These are not fundamentally the same suggestions, please decouple them
Re: Ability to send quality signals for "set filter"
Posted: Sat Oct 04, 2025 1:02 pm
by Koub
protocol_1903 wrote: Sat Oct 04, 2025 10:38 am
These are not fundamentally the same suggestions, please decouple them
Okay, they seemed pretty similar to me though.
[Koub] Resplit both suggestions.