[2.0.28] Cryogenic plant prioritizing output to pipe over tank
Posted: Sat Dec 28, 2024 9:59 am
Noticed that the fluid outputs from a Cryogenic plant will prefer going into a pipe over direct into a tank
Upon placing a fluid tank directly connected to the lowest output of a Cryo plant it would prefer outputting only to the pipes until they were to completely fill, completely ignoring the tank until then
This lead to it never actually outputting to the tank until the pipes were full acting as an overflow instead of equally outputting to all
Upon placing a fluid tank directly connected to the lowest output of a Cryo plant it would prefer outputting only to the pipes until they were to completely fill, completely ignoring the tank until then
This lead to it never actually outputting to the tank until the pipes were full acting as an overflow instead of equally outputting to all