[2.0.21] Parametrising blueprint of bulk inserters will set stack sizes to 1
Posted: Fri Nov 22, 2024 4:12 pm
What did you do?
-place 2 bulk inserters
-change the stacksize to 6 and the other one to 8
-make a blueprint
-click parametrise
-paremetrise the 6
It will allrdy change both values in this menue, but you can save the blueprint and place it and check both stacksizes
What happened?
Both stacksize values changed to 1
What did you expect to happen instead? It might be obvious to you, but do it anyway!
I would expect 2 inserters. one with stacksize 4 and one with stacksize 8
Does it happen always, once, or sometimes?
Works allways. you can choose ANY blueprint with a fixed stacksize and just change ANY value to parametrise. (for example 1 inserter with stacksize 2 and one assembler with a mining drill recipe selected. parametrise the recipe and the stacksize will go to 1, even if it should not be changed.
a filter on a single inserter works aswell.
-place 2 bulk inserters
-change the stacksize to 6 and the other one to 8
-make a blueprint
-click parametrise
-paremetrise the 6
It will allrdy change both values in this menue, but you can save the blueprint and place it and check both stacksizes
What happened?
Both stacksize values changed to 1
What did you expect to happen instead? It might be obvious to you, but do it anyway!
I would expect 2 inserters. one with stacksize 4 and one with stacksize 8
Does it happen always, once, or sometimes?
Works allways. you can choose ANY blueprint with a fixed stacksize and just change ANY value to parametrise. (for example 1 inserter with stacksize 2 and one assembler with a mining drill recipe selected. parametrise the recipe and the stacksize will go to 1, even if it should not be changed.
a filter on a single inserter works aswell.
