[0.18.1] input signals for inserter and pump is not shown
Posted: Sat Feb 08, 2020 5:53 am
The input signal for the pump and inserter inserter is not showing
when we use a combinator and connect it with red or green wire, it shows the input signals it receives.
The inserter also has the option to enable / disable based on a condition, when connected with a red/green wire, but but the input signals received by a inserter/pump is not shown when connected with a red/green wire .
when we use a combinator and connect it with red or green wire, it shows the input signals it receives.
The inserter also has the option to enable / disable based on a condition, when connected with a red/green wire, but but the input signals received by a inserter/pump is not shown when connected with a red/green wire .